|
Home > Installation Instructions
| | |
|
|
Installation
Instructions for Seat Covers
Note:
These instructions are general guidelines for the installation of
sheepskin seat covers. Due to the wide variety of seat styles, actual
installation steps may vary.
To
view our installation videos, you'll need to download Apple's
Quicktime.
Check
out our blog
for more installation tips. |
 |
| Step 1 |
|
view
photo
view
video (6mb)
|
| 1. Lowback
seats with removable headrests - Remove headrest
completely from seat (see photo).
2. Lowback seats with
non-removable headrests - Your seat cover will have
a velcro strip that must pulled apart and slipped over
headrest.
3. Highback seats with
integrated headrests - The seat cover will slip over
the whole seat.
view photo |
|
| Step 2 |
|
view
photo
view video
|
| Recline the
backrest portion of your seat, fitting cap over top of
seat.
view photo
|
|
| Step 3 |
|
view
photo
view video
|
| Take the three
straps in center seam of seat cover and pull them
(tugging hard) through the break between the seat and
backrest. If seat does not allow for center break strap
topull through, cut provided straps off.
view photo
|
|
|
| Step 4 |
|
view
photo
view video
|
| Take the
front corners of seat cover (in sitting position) and
turn them inside out and place them on the seat corners.
Keeping seam of seat cover lined up with seam of
vehicle's seat, turn (fold) cover back to normal by
working your way to center of seat from either corner.
|
|
| Step 5 |
|
view
photo
view video
|
| Bring backrest
upright and tuck in all excess sheepskin into break of
seat. (If seat is designed with bottom molding, tuck in
excess side skirts of seat cover into plastic molding). |
|
| Step 6 |
|
view
photo
view video
|
| Take shorter center strap
and attach to any portion under the seat. Attach metal
hooks on long outside straps (one at a time) to hole in
white fitting rod provided. Pull rod through under seat
to the front. |
|
|
| Step 7 |
|
view
photo
view video
|
| Unclip hooks from fitting
rod and connect to 'D' rings located on the front of the
seat cover. May not be used if 'D' rings are not
present. |
|
| Step 8 |
|
view
photo
view video
|
| Take remaining straps
found on side panels of upper half and lower half of
cover and fasten to any attachment under seat. |
|
| Step 9 |
|
view
photo
view video
|
| For lowback seats only
(seats with an adjustable headrest). You should now have
a snug fit and be ready to replace headrests. After
locating position of headrest shafts, use a sharp
instrument to pierce cover, cutting a small slit. Insert
headrest poles through cover and into the headrest
shafts. |
|
|
| |
| | |
|
|